The 7.62×51mm NATO (official NATO nomenclature 7.62 NATO) is a rimless bottlenecked rifle cartridge developed in the 1950s as a standard for small arms among NATO countries. It should not be confused with the similarly named Russian 7.62×54mmR cartridge, a slightly longer rimmed cartridge. It was introduced in U.S. service in the M14 rifle and M60 machine gun in the late 1950s. The M14 was superseded in U.S. service as the infantry adopted the 5.56×45mm NATO M16. However, the M14 and many other firearms that use the 7.62×51 round remain in service, especially in the case of various sniper rifles, medium machine guns such as the M240, and various rifles in use by special operations forces. The cartridge is used both by infantry and on mounted and crew-served weapons mounted to vehicles, aircraft and ships. Although not identical, the 7.62×51mm NATO and the commercial .308 Winchester cartridges are similar enough that they can be loaded into rifles chambered for the other round, but the Winchester .308 cartridges are typically loaded to higher pressures than 7.62×51mm NATO cartridges for use in long-distance hunting of big-game animals. Even though the Sporting Arms and Ammunition Manufacturers' Institute (SAAMI) does not consider it unsafe to fire the commercial round in weapons chambered for the NATO round, there is significant discussion about compatible chamber and muzzle pressures between the two cartridges based on powder loads and wall thicknesses on the military vs. commercial rounds. While the debate goes both ways, the ATF recommends checking the stamping on the barrel; if one is unsure, one can consult the maker of the firearm. The cartridge itself offers similar ballistic performance in most firearms to the .30-06 Springfield that it replaced in U.S. service. Though shorter, standard loadings fire similar bullet weights with only a slight reduction in velocity. Modern propellants allowed for similar performance from a case with less capacity. The smaller case requires less brass and yields a shorter cartridge. This shorter cartridge allows a slight reduction in the size and weight of firearms that chamber it, and somewhat better cycling in automatic and semi-automatic rifles. How the bullets are made in USA factories ? weaponry military power American 美國子彈工廠製作流程,for more information about china world news visit site at http://youtube.com/user/militaryculture as well as business website at http://penglaimachines.coma